Manual Alarm Panel not showing pending state

Hi !
I’m using the Manual Alarm Control Panel, but when i activate the alarm (or when the alarm is triggered) , it go into “Pending” state before going into “Armed” state, but in Home Habit, it’s directly shown as “Armed”.
I have check, in home assistant it’s correctly set has “Pending” state.
I don’t now if it’s a bug or if it’s voluntary but it’s not very intuitive when you use it.

Yes, pending states are currently not supported, so it is expected behavior for the app to show eventual state immediately. I will see if this is something that can be improved in the near future.

Ok, nice !
I will look at it closely !

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.